Brass Nautical Piling Light – Authentic Nautical Light
Quantity: 20 Piece In Stock
Free Shipping in the continental US
Click on the photo to see additional images of this Russell and Stoll nautical light.
The heavy construction of this explosion proof light allows this stunning piece to weigh in at just under 21 pounds. Russell and Stoll made this light to measure 13 inches tall. The base measures 4 3/4 inches square with the widest section of the light housing measuring almost 7 inches wide. The undamaged glass globe is about 6 inches tall and has raised ribs on the interior surface that helps magnify the displacement of the light.
To access the bulb, the top section of the light spins free off the base. The top section that spins off as one piece consists of the cage, the globe, and the large cast bronze section just below the globe.
We have installed a new bulb socket made by Westinghouse Electric that is UL-Listed and rated for any voltage under 250 volts. Additionally, we have installed new wiring including a ground wire that exits the light from the center of the base. The original conduit hole on the lower housing as been fitted with a threaded brass plug. The housing on this light has the original builders plate that includes the Underwriters Laboratory certification.
This original light is a very rare and hard to find piece. Besides being used as a ceiling or post light, this light could have a cord added to it and be used as a very impressive desk or counter top light.
We have several matched pieces of this Russell and Stoll light in stock.
Quantity: 100 Pieces In Stock
If you would like to see additional views of this authentic nautical piling light, just click on the photo.
This is another authentic nautical piling light in our inventory. The light measures about 11 1/2 inches tall and about 9 1/2 inches wide. The weight of the light is a little over 23 pounds. This authentic nautical piling light has a mount base with three mount holes that are 4 3/4 inches on center. It also has a very thick Fresnel lens with minor wear.
This authentic nautical piling light has been completely rewired with modern UL-Listed wiring. The new bulb socket was made by Westinghouse Electric and it takes a common screw in house bulb of 100 watts or less. The new UL-Listed wiring and bulb socket are all rated to work with any electrical voltage under 250 volts. This light also has a pre-installed new ground wire. To access the bulb holder you loosen the three thumb screws on top.
This functional authentic nautical piling light will add a true nautical touch to wherever it is installed and is a must have for those who appreciate high quality nautical decor. Authentic maritime collectibles will last a lifetime and are among our top favorites found in our broad, coastal themed collection of nautical lighting products. The solid cast brass construction of this true vintage nautical light makes it a perfect fit for interior or exterior lighting projects.
Ready to order this great light? Just give us a call at 574-870-1571 and we can get your order started today.
You will be shipped the authentic nautical piling light shown in the photos.
Quantity: 1 Piece In Stock
Click on the photo to see additional views of this vintage weather tight cast brass nautical piling light.
I think it is hard to tell by looking at the photos of this vintage weather tight cast brass nautical piling light, but it weighs just over 17 pounds. While it may not have the typical post designed base that other lights have in this category, it would be a perfect selection if you need a light to sit on top of a pier piling or a stone structure at the end of your driveway.
This weather tight cast brass nautical piling light measures 11 inches tall and at the widest point it measures about 8 inches wide. The heavy duty cast brass base has two mounting legs with holes that are about 7 1/2 inches on center of each other. This weather tight cast brass nautical piling light can be mounted with the glass pointing up or down. In other words, it can also be considered as a very large over head light.
Because of the construction design, this light can withstand direct water spray, and the bulb compartment will remain water tight. To access the bulb, the cage and globe spin off as one piece. This design requires no tools to change the bulb!
Originally the wiring entered one of the two side conduit holes. We have enclosed the original conduit holes with copper caps, and a new hole has been drilled in the center of the base that will allow for a very clean installation. This vintage weather tight cast brass nautical piling light was completely rewired with a new UL-Listed bulb holder that was made by Westinghouse Electric. The bulb holder takes a normal screw in house bulb of 100 watts or less. The all new wiring is suited for any voltage under 250 volts, so your normal house voltage is no an issue.
This light has a weathered look and the cage will have the normal bends and possible repairs. If you are looking for a true vintage nautical light that looks like it really came from the deck of a working vessel, this is your light!
Quantity: 32 Pieces In Stock
Click on the photo to see additional images of this Tranberg post light with red Fresnel lens.
This Tranberg post light with red Fresnel lens is made of solid cast brass material. The red 360 degree lens is made of glass and has minor edge chipping and a slight weathered look. This Tranberg post light with Fresnel lens measures almost 14 inches tall and is about inches wide. The mounting flange is 5 inches in diameter with three mount holes. This Tranberg post light with red Fresnel lens weighs about 17 pounds.
We have installed an all new porcelain bulb holder, wiring, and a ground wire. All new electrical parts are UL-Listed and rated to work with any voltage under 250 volts. The bulb holder takes a normal screw-in house bulb of 100 watts or less. The new wiring terminates inside the post mount.
This Tranberg post light with red Fresnel lens is a great example of lights from the past. Tranberg was the maker, and they produced a wide selection of nautical lights.
This light design can be used on top of a dock, sea wall piling, or entry light. With this authentic nautical light being constructed of all cast brass, you can use it for interior or exterior projects – it will last forever!
One piece in stock – you will be shipped the Tranberg post light with red Fresnel lens shown in the photos.
Quantity: 1 Piece In Stock