Copper Marine Anchor Light
Quantity: 1 Piece In Stock
Free Shipping in the continental US
Click on the photo to see additional views of this vintage frosted perko navigation light.
This vintage frosted perko navigation light measures about 14 1/2 inches tall x about 10 inches wide. The 360 degree plastic Fresnel lens is frosted and in good condition. Weighs about 9 pounds. Housing is galvanized iron.
We have installed a two prong power cord that allows this light to just plug into a normal wall outlet. The cord has a on/off switch. Requires a normal screw in house bulb of 75 watts or less.
To access the bulb area, unscrew the plastic top.
You will be shipped the vintage frosted perko navigation light shown in the photos.
Quantity: 1 piece in stock
Click on the photo to see additional views of these huge marine navigation lights.
Here is a most impressive set of three matched double stack marine navigation lights. Each light stands about 25 inches tall and measures about 14 inches wide. Each light weighs about 30 pounds, so the three piece set total weight is around 90 pounds. These marine navigation lights are made of copper and have some brass trim. Each light has two fresnel globes, and they are made of 3/4 inch thick glass. The globes are all in good condition with just some minor edge flaking – no cracks or holes. The globes on the left hand light show a little more weathering than the other two, but this is not a big issue. The top of the left hand light is dented in. This can be beat out, but I will leave that up to the new owners.
The copper housing of each light will have some dents and dings as they are real lights recovered from a salvage yard operation. The port and starboard lights have clear fresnel glass with a red and green colored insert behind the clear glass. When you install bulbs and turn on the power, the red and green will be quite noticeable. We have re-wired all three lights with all new UL-Listed wiring and two new bulb holders in each light. The new electrical parts are rated to work with any voltage under 250 volts. The bulb holders uses a normal screw in house bulb of 75 watts or less. All three marine navigation lights have some surface wear.
You will be shipped the set of three marine navigation lights shown in the photos.
Click on the photo to see additional views of these three vintage oil burning lights.
I found this three piece set of vintage oil burning lights together at the shipyard, but I am not 100% sure if they were made by the same maker. The center light has the makers’ mark “Ahlemann and Schlatter Breman”. The left and right hand side lights do not have a makers’ mark, but they may have been made by “Luz De Navegaco BB”.
These three vintage oil burning lights are about 19 1/2 inches tall each. The left and right lights are made to fit into a corner. Measuring from the point of the corner back to the curved front, each measures 11 inches deep. As you look at them from the front, they are 13 inches wide. The fresnel glass is clear, but there are red and green inserts on the inside that makes them look red and green. The inserts can be removed and they are clear in color. The center light has a flat back, and measures 9 1/2 inches wide. The glass lenses are in very good condition but need some cleaning up. The oil burners look complete but have not been tested for working condition or leaks. You may need to replace the wicks and/or do some additional cleaning to them if you want to burn them.
The main housing of these lights is made of galvanized iron and the top covers are all three made of copper. The lights have surface rust and have been clear coated. The center light has some rust through on one corner on the bottom side (see photos). The right and left hand lights have no rusting through. The center light is missing part of the latch that holds the back access door closed. These lights may have some minor dents, dings, and scrapes that are not totally visible in the attached photos.
You will be shipped the set of three vintage oil burning lights shown in the photos.
Click on the photo to see additional views of this 3 piece authentic wall mount navigation light set.
This original 3 piece authentic wall mount navigation light set can be used for interior or exterior projects. Each light in this set weighs nearly 15 pounds. Each light measures about 9 inches tall and about 8 inches wide. The 360 degree fresnel glass globes are in good condition with some light edge chipping. The back of the lights have four mount legs. The top access cover is held closed by a wing nut that works freely.
All new Westinghouse Electric wiring (including a ground wire) and a new bulb holder have been installed. Rated for any voltage under 250 volts are and UL-listed. The original wiring and conduit entered the front junction box. We have plugged the original conduit hole on the side with a copper cap. A new hole was drilled on the bottom housing. A 90-degree brass fitting was added and a copper pipe was installed in this fitting. This new copper pipe extends just past the wall mounts. You can bring this new pipe into the wall, or fit your junction box with a cover plate and then drill a 1/2 hole that will allow the new pipe to hide all the wiring and protect it from the weather.
You will be shipped the 3 piece authentic wall mount navigation light set shown in the photos.
Quantity: 1 Set in stock