Authentic 360 Degree Navigation Light
Quantity: 1 Piece In Stock
Free Shipping in the continental US
Click on the photo to see additional views of this heavy duty navigation light.
This heavy duty navigation light measures about 11 inches tall including the handle on top x about 12 inches wide. The 360 degree fresnel glass globe is clear with only a few minor scratches here and there.
We’ve added a white electrical cord with plug.
This heavy duty navigation light is made of cast brass and weighs nearly 24 pounds.
To access the bulb area, unscrew the two nuts on the top. This light has been re-wired and a new bulb holder installed. All the new electrical parts we install are UL-Listed and rated to work with any voltage under 250 volts. The bulb holder takes a normal screw in type bulb of 100 watts or less.
You will be shipped the heavy duty navigation light shown in the photos.
Click on the photo to see additional views of this German made oil burning lantern.
This vintage galvanized German made oil burning lantern has a nice weathered look, but no rusting through! It was made by “Ahlemann and Schlatter Bremen”. Most of the housing has surface rust and has been clear coated. The main housing is made from galvanized iron and the top vent cover is made from copper. As shown in the photo to the left, this lantern is 17 inches tall with the top handle in the down position. The fresnel glass lens is in very good condition, but could use some additional cleaning! Not 100% sure, but I would call this a 145 degree lens. This is a flat back housing with the back side being 7 1/2 inches wide. From the curved front of the lantern to the flat back, it looks to measure about 7 1/2 inches. This German made oil burning lantern weighs just over 8 pounds.
The back side of this lantern has a door that gives easy access to the oil burner. The burner assembly looks complete, but it has not been tested for working condition or leaks, and will need some cleaning if you really want to light it up. The oil burner will need a new wick. The back access door has a slight bend in it, and as you can see in the additional photos, it has a small gap at the bottom when closed.
This is an original German made oil burning lantern that was recovered from a salvage yard operation. This lantern may have some minor dents, dings, and scrapes that are not totally visible in the attached photos. The housing does not show any signs of rusting through.
You will be shipped the German made oil burning lantern shown in the photos
Click on the photo to see additional views of this vintage masthead navigation running light.
This stunning vintage masthead navigation running light measures 3 1/4 inches wide by 2 inches, including the flanges on the sides. Including the bottom wiring section of the light, it is about 3 inches tall. The undamaged glass lens is clear, and the body is made of brass. There are two mounting screws on the brass body about 1 3/4 inches apart. This little light is likely from the 1950’s.
The wiring and bulb in the light are all original, nothing has been replaced.
You will be shipped the navigation light shown in the photos.
Quantity: 1 Piece In Stock
Click on the photo to see additional views of these three vintage oil burning lights.
I found this three piece set of vintage oil burning lights together at the shipyard, but I am not 100% sure if they were made by the same maker. The center light has the makers’ mark “Ahlemann and Schlatter Breman”. The left and right hand side lights do not have a makers’ mark, but they may have been made by “Luz De Navegaco BB”.
These three vintage oil burning lights are about 19 1/2 inches tall each. The left and right lights are made to fit into a corner. Measuring from the point of the corner back to the curved front, each measures 11 inches deep. As you look at them from the front, they are 13 inches wide. The fresnel glass is clear, but there are red and green inserts on the inside that makes them look red and green. The inserts can be removed and they are clear in color. The center light has a flat back, and measures 9 1/2 inches wide. The glass lenses are in very good condition but need some cleaning up. The oil burners look complete but have not been tested for working condition or leaks. You may need to replace the wicks and/or do some additional cleaning to them if you want to burn them.
The main housing of these lights is made of galvanized iron and the top covers are all three made of copper. The lights have surface rust and have been clear coated. The center light has some rust through on one corner on the bottom side (see photos). The right and left hand lights have no rusting through. The center light is missing part of the latch that holds the back access door closed. These lights may have some minor dents, dings, and scrapes that are not totally visible in the attached photos.
You will be shipped the set of three vintage oil burning lights shown in the photos.