Vintage Nautical Ceiling Light
Quantity: 1 Piece In Stock
Free Shipping in the continental US
Click on the photo to see additional views of this nautical light with red globe.
This is a cast brass ceiling nautical light with red globe. It weighs just over 6 1/2 pounds and measures 7 1/2 inches tall. The mounting base is 4 7/8 inches wide including the 2 mount holes. The globe is red glass and undamaged.
We have installed all new wiring and a bulb holder made by Westinghouse and has the UL-Listed marks. The wiring and bulb holder are rated to work with any voltage under 250 volts for indoor and exterior lighting use. The bulb holder takes a normal screw in house bulb of 60 watts or less.
The light must point downward when installed to prevent moisture from getting inside the fixture.
This is the only one in stock so you will be shipped the nautical light with red globe shown in the photos.
Quantity: 1 piece in stock
Click on the photo to see additional views of this cast brass vintage nautical ceiling light.
This light is about 11 inches tall and the added brass deflector cover is about 20 inches in diameter.
The 360 degree glass Fresnel lens measures about 8 1/2 inches in diameter and has minor edge flaking.
The ceiling mount has three mount holes.
The light weighs about 25 pounds.
Re-wired, including a ground wire, and has a porcelain bulb socket that is UL-Listed. Rated to work with any voltage under 250 volts. It takes a common screw in house bulb of 75 watts or less. The bulb socket can be accessed by removing the three thumb screws and opening the lid.
You will be shipped the cast brass vintage nautical ceiling light shown in the photos.
Quantity: 1 Piece In Stock
Click on the photo to see additional views of this covered brass engine room ceiling light.
This is an original covered brass engine room ceiling light to which we added the 10 inch wide brass deflector cover. This light will extend down from the ceiling by 8 inches when mounted. The two original conduit openings on the front have been fitted with brass plugs. This light weighs nearly 5 pounds.
This light has been re-wired with all new UL-Listed parts that are rated for any voltage under 250 volts. We have also included a ground wire. The bulb holder takes a normal screw in house bulb of 75 watts or less, or you can use the newer compact fluorescent bulbs or LED lights with an Edison base.
This is a beautiful light that can be used inside or outside.
Quantity: 1 + Matched Pieces
Click on the photo to see additional views of this brass hanging light with copper deflector cap.
We started out with a common ceiling mounted cast brass nautical light and made it into this classy looking vintage reclaimed nautical pendant light with copper deflector cover ready to hang with 2 1/2 feet of brass chain. We added the 8 inch copper deflector cover to greatly change the look. The light measures about 13 inches long, from the tip of the handle to the bottom of the cage. It weighs about 7 pounds. Originally this light had a steel conduit pipe attached to the side to supply the electrical power. We removed the conduit and plugged the hole with a threaded brass cap.
We then added the brass handle at the top of the nautical pendant light with copper deflector cover to polish it all off. All the old wiring and bulb holder was removed and new UL-Listed parts were re-installed that are rated to work with any voltage under 250 volts. The new bulb holder takes an Edison base bulb of 50 watts or less. To access the bulb, you just spin off the brass cage and the undamaged glass globe.
This brass hanging light with copper deflector cap will be shipped with 2 1/2 feet of chain and wire, but you will need to supply the means to attach to your ceiling.
We have 7 pieces like this in stock, however these pieces are not identical and there may be some variation between pieces.
Quantity: 7 Matched Pieces