Nautical Ceiling Light With Glass Globe
Quantity: 18 Pieces In Stock
Free Shipping in the continental US
Click on the photo to see additional views of this brass hanging light with copper deflector cap.
We started out with a common ceiling mounted cast brass nautical light and made it into this classy looking vintage reclaimed nautical pendant light with copper deflector cover ready to hang with 2 1/2 feet of brass chain. We added the 8 inch copper deflector cover to greatly change the look. The light measures about 13 inches long, from the tip of the handle to the bottom of the cage. It weighs about 7 pounds. Originally this light had a steel conduit pipe attached to the side to supply the electrical power. We removed the conduit and plugged the hole with a threaded brass cap.
We then added the brass handle at the top of the nautical pendant light with copper deflector cover to polish it all off. All the old wiring and bulb holder was removed and new UL-Listed parts were re-installed that are rated to work with any voltage under 250 volts. The new bulb holder takes an Edison base bulb of 50 watts or less. To access the bulb, you just spin off the brass cage and the undamaged glass globe.
This brass hanging light with copper deflector cap will be shipped with 2 1/2 feet of chain and wire, but you will need to supply the means to attach to your ceiling.
We have 7 pieces like this in stock, however these pieces are not identical and there may be some variation between pieces.
Quantity: 7 Matched Pieces
Click on the photo to see additional views of this unusual Pauluhn ceiling light
This is a rather unusual Pauluhn ceiling light. Made of cast brass. This light measures about 8 1/2 inches tall x 6 inches wide. Beautiful teal blue ribbed globe. The top ring of the fixture is marked “Pauluhn Electric Mfg. Co. Pearland, TX”. The single conduit hole in front was fitted with a copper cap. Weighs a hefty 8 1/2 pounds!!
The new bulb holder takes a normal screw in house bulb of 75 watts or less. We drilled a small hole in the base of the light for the wiring to exit and not be seen after installation. The new wiring will work with any voltage under 250 volts and includes a ground wire. Remove the four screws on the cage to access the bulb holder.
This light can also be used as a piling or post light as it is weatherproof.
You will be shipped the unusual Pauluhn ceiling light shown in the photos.
Quantity: 1 Piece In Stock
Click on the photo to see additional views of this vintage nautical ceiling light with brass deflector cover.
This original nautical ceiling light with brass deflector cover will extend down from the mount surface by about 9 inches. To access the bulb, you spin off the brass cage and the glass globe. The top of the nautical ceiling light with brass deflector cover has three mounting legs. The cover is removable.
The new bulb holder takes a normal screw in house bulb of 75 watts or less. We drilled an exit hole on the top of the light that allows the wiring to not be seen after installation. The new wiring will work with any voltage under 250 volts. The two conduit holes on the front of the light have had brass plugs installed.
Give us a call at 574-870-1571 to order this nautical ceiling light with brass deflector cover in stock.
Quantity: 2 Pieces in Stock
You can see additional views of this hanging pendant light by clicking on the photo.
This vintage nautical hanging pendant light is about 17 inches tall measuring from the bottom of the cage to the top of the hanging loop. There is 4 feet of chain at the top, which can be shortened or lengthened. The brass rain cap measures 12 1/2 inches in diameter. The light weighs about 27 pounds.
These nautical lights have been totally rewired with all UL-Listed wiring and a porcelain bulb holder. They can take a normal screw in house bulb of 100 watts or less. The new wiring includes a ground wire and exits the light from the center of the light. The new wiring is rated to work with any voltage under 250 volts.
Several pieces in stock!!
Quantity: 7 Pieces In Stock