Nautical Ceiling Light With Brass Deflector Cover
Quantity: 2 Pieces in Stock
Free Shipping in the continental US
Click on the photo to see additional views of this unusual Pauluhn ceiling light
This is a rather unusual Pauluhn ceiling light. Made of cast brass. This light measures about 8 1/2 inches tall x 6 inches wide. Beautiful teal blue ribbed globe. The top ring of the fixture is marked “Pauluhn Electric Mfg. Co. Pearland, TX”. The single conduit hole in front was fitted with a copper cap. Weighs a hefty 8 1/2 pounds!!
The new bulb holder takes a normal screw in house bulb of 75 watts or less. We drilled a small hole in the base of the light for the wiring to exit and not be seen after installation. The new wiring will work with any voltage under 250 volts and includes a ground wire. Remove the four screws on the cage to access the bulb holder.
This light can also be used as a piling or post light as it is weatherproof.
You will be shipped the unusual Pauluhn ceiling light shown in the photos.
Quantity: 1 Piece In Stock
Click on the photo to see additional views of this solid cast brass nautical ceiling light with a brass deflector cover.
This is an original cast brass nautical ceiling light with a stainless steel cage. We added the 8 inch wide brass deflector cover to this original cast brass ceiling light to dress it up a little. This cast brass nautical ceiling light will extend down from the ceiling by just about 8 inches when mounted. The base of the light has two mounting holes that are almost 4 inches on center of each other. Weighs about 7 pounds. The cage spins on and off freely and holds the undamaged glass globe in place as well as the deflector cover. Also, some of the cages may be slightly bent here and there.
The light has been re-wired with all new UL-Listed parts that are rated for any voltage under 250 volts. The bulb holder takes a normal screw in house bulb of 75 watts or less, or you can use the newer compact fluorescent bulbs or LED lights with an Edison base.
This cast brass nautical ceiling light can be used for interior or exterior lighting projects. The original conduit holes have been fitted with threaded brass plugs and a new hole has been drilled in the base to allow the wiring to exit right into the ceiling.
This is a used cast brass nautical ceiling light that was recovered during one our many different salvage operations. It will have minor surface wear from being used on a working vessel.
We have a large number of these lights in stock!!
Quantity: 75 Pieces In Stock
Click on the photo to see additional views of this large round cast brass ceiling light.
This large round cast brass ceiling light measures about 14 inches long, including the junction box on the front x about 10 inches wide. It will extend down from the mounting surface by about 6 inches. The back has three mounting legs. It weighs 11 1/2 pounds.
To access the bulb, you need only to unscrew the three thumbscrews around the outside edge of the light. The cover is hinged. The glass in this light is frosted. The original rubber seal was in poor condition so we replaced it with a rope one.
We have installed a new UL-Listed bulb socket and wiring, including a ground wire. The wiring and bulb socket are rated to work with any voltage under 250 volts. The bulb socket takes a normal screw-in house bulb of 75 watts or less.
This large round cast brass ceiling light can be used for interior or exterior projects and will provide a long life even in a saltwater environment.
We have several pieces of this large round cast brass ceiling light in stock.
Quantity: 12 Pieces In Stock
Click on the photo to see additional views of this nautical hanging light with brass deflector cap.
We started out with a common ceiling mounted cast brass nautical light and made it into this classy looking vintage reclaimed nautical pendant light with brass deflector cover ready to hang with 2 1/2 feet of brass chain. We added the 8 inch brass deflector cover to greatly change the look. The light measures about 13 inches long, from the tip of the handle to the bottom of the cage. It weighs about 7 pounds. Originally this light had a steel conduit pipe attached to the side to supply the electrical power. We removed the conduit and plugged the hole with a threaded brass cap.
We then added the brass handle at the top of the nautical pendant light with brass deflector cover to polish it all off. All the old wiring and bulb holder was removed and new UL-Listed parts were re-installed that are rated to work with any voltage under 250 volts. The new bulb holder takes an Edison base bulb of 50 watts or less. To access the bulb, you just spin off the brass cage and the undamaged glass globe.
This nautical hanging light with brass deflector cap will be shipped with 2 1/2 feet of chain and wire, but you will need to supply the means to attach to your ceiling.
We have five pieces like this in stock, however they are not all identical and there may be some variation between pieces.
Quantity: 4 Matched Pieces