Engine Room Ceiling Light w/Brass Deflector Cover
Quantity: 16 + Matched Pieces
Free Shipping in the continental US
Click on the photo to see additional views of this nautical light with red globe.
This is a cast brass ceiling nautical light with red globe. It weighs just over 6 1/2 pounds and measures 7 1/2 inches tall. The mounting base is 4 7/8 inches wide including the 2 mount holes. The globe is red glass and undamaged.
We have installed all new wiring and a bulb holder made by Westinghouse and has the UL-Listed marks. The wiring and bulb holder are rated to work with any voltage under 250 volts for indoor and exterior lighting use. The bulb holder takes a normal screw in house bulb of 60 watts or less.
The light must point downward when installed to prevent moisture from getting inside the fixture.
This is the only one in stock so you will be shipped the nautical light with red globe shown in the photos.
Quantity: 1 piece in stock
Click on the photo to see additional views of this brass hanging light with copper deflector cap.
We started out with a common ceiling mounted cast brass nautical light and made it into this classy looking vintage reclaimed nautical pendant light with copper deflector cover ready to hang with 2 1/2 feet of brass chain. We added the 8 inch copper deflector cover to greatly change the look. The light measures about 13 inches long, from the tip of the handle to the bottom of the cage. It weighs about 7 pounds. Originally this light had a steel conduit pipe attached to the side to supply the electrical power. We removed the conduit and plugged the hole with a threaded brass cap.
We then added the brass handle at the top of the nautical pendant light with copper deflector cover to polish it all off. All the old wiring and bulb holder was removed and new UL-Listed parts were re-installed that are rated to work with any voltage under 250 volts. The new bulb holder takes an Edison base bulb of 50 watts or less. To access the bulb, you just spin off the brass cage and the undamaged glass globe.
This brass hanging light with copper deflector cap will be shipped with 2 1/2 feet of chain and wire, but you will need to supply the means to attach to your ceiling.
We have 7 pieces like this in stock, however these pieces are not identical and there may be some variation between pieces.
Quantity: 7 Matched Pieces
Click on the photo to see additional views of this nautical ceiling light with frosted globe.
This is an original cast brass nautical ceiling light with a frosted globe. We added the 8 inch wide brass deflector cover to dress it up a little. This cast brass nautical ceiling light will extend down from the ceiling by just about 8 inches when mounted. The base of the light has two mounting holes that are almost 4 inches on center of each other. Weighs about 7 pounds. The cage spins on and off freely and holds the frosted glass globe in place as well as the deflector cover. The deflector cover is removable.
The light has been re-wired with all new UL-Listed parts that are rated for any voltage under 250 volts. The bulb holder takes a normal screw in house bulb of 75 watts or less, or you can use the newer compact fluorescent bulbs or LED lights with an Edison base.
This cast brass nautical ceiling light with frosted globe can be used for interior or exterior lighting projects. The original conduit holes have been fitted with threaded brass plugs and a new hole has been drilled in the base to allow the wiring to exit into the ceiling.
Several pieces in stock!!
Quantity: 3 Pieces In Stock
Click on the photo to see additional views of this beautiful reclaimed polished brass pendant light.
We started out with a reclaimed brass nautical ceiling light. Once the original light was polished, we fitted it with an 8 1/4 inch wide polished brass deflector cover. The center hole on the top housing was threaded and a brass down rod was added. The down rod has a 3 1/4 inch ceiling mount plate with three mounting holes. This reclaimed polished brass pendant light will extend down from the ceiling about 14 inches and the total weight is about 4 1/2 pounds.
This reclaimed polished brass pendant light was then totally rewired with UL-Listed wiring with a ground wire and bulb holder that is rated for any voltage under 250 volts. The new bulb holder takes a common house bulb of 65 watts or less. To access the bulb, the deflector cover and undamaged glass globe spin off separately.
Great looking pendant light! When mounted, the light must point downward to avoid getting moisture inside the globe.
Please give us a call at 574-870-1571 to order this item number. And as always, shipping is free here in the continental US!
We have several pieces of this reclaimed polished brass pendant light in stock!
Quantity: 19 Pieces In Stock