Vintage Brass Nautical Ceiling Light With Cover
Quantity: 1 Piece In Stock
Free Shipping in the continental US
Click on the photo to see additional views of this nautical light with red globe.
This is a cast brass ceiling nautical light with red globe. It weighs just over 6 1/2 pounds and measures 7 1/2 inches tall. The mounting base is 4 7/8 inches wide including the 2 mount holes. The globe is red glass and undamaged.
We have installed all new wiring and a bulb holder made by Westinghouse and has the UL-Listed marks. The wiring and bulb holder are rated to work with any voltage under 250 volts for indoor and exterior lighting use. The bulb holder takes a normal screw in house bulb of 60 watts or less.
The light must point downward when installed to prevent moisture from getting inside the fixture.
This is the only one in stock so you will be shipped the nautical light with red globe shown in the photos.
Quantity: 1 piece in stock
Click on the photo to see additional views of this large Pauluhn ceiling light
Here we have this interesting large Pauluhn ceiling light. Made of cast brass. This light measures about 8 1/2 inches tall x about 6 inches wide. Beautiful teal blue ribbed globe. This light is marked “Pauluhn Electric Mfg. Co. Pearland, TX”. The single conduit hole was fitted with a brass cap. Weighs a hefty 9 pounds!!
The new bulb holder takes a normal screw in house bulb of 75 watts or less. We drilled a small hole in the base of the light for the wiring to exit and not be seen after installation. The new wiring will work with any voltage under 250 volts and includes a ground wire. Remove the four screws on the cage to access the bulb holder.
This light can also be used as a piling or post light as it is weatherproof.
You will be shipped the large Pauluhn ceiling light shown in the photos.
Quantity: 1 Piece In Stock
Click on the photo to see additional views of this brass hanging light with copper deflector cap.
We started out with a common ceiling mounted cast brass nautical light and made it into this classy looking pendant light ready to hang with 2 1/2 feet of brass chain. We added the 8 inch copper deflector cover to greatly change the look. The light measures about 13 inches long, from the tip of the handle to the bottom of the cage. It weighs about 7 pounds. Originally this light had a steel conduit pipe attached to the side to supply the electrical power. We removed the conduit and plugged the hole with a threaded brass cap.
We then added the brass handle at the top of the nautical pendant light with copper deflector cover to polish it all off. All the old wiring and bulb holder was removed and new UL-Listed parts were re-installed that are rated to work with any voltage under 250 volts. The new bulb holder takes an Edison base bulb of 75 watts or less. To access the bulb, spin off the brass cage and the undamaged glass globe.
This brass hanging light with copper deflector cap will be shipped with 2 1/2 feet of chain and wire, but you will need to supply the means to attach to your ceiling.
We have 5 pieces like this in stock; however these pieces are not identical and there may be some variation between pieces.
Quantity: 5 Matched Pieces
You can see additional views of this hanging pendant light by clicking on the photo.
This vintage nautical hanging pendant light is about 17 inches tall measuring from the bottom of the cage to the top of the hanging loop. There is 4 feet of chain at the top, which can be shortened or lengthened. The brass rain cap measures 12 1/2 inches in diameter. The light weighs about 27 pounds.
These nautical lights have been totally rewired with all UL-Listed wiring and a porcelain bulb holder. They can take a normal screw in house bulb of 100 watts or less. The new wiring includes a ground wire and exits the light from the center of the light. The new wiring is rated to work with any voltage under 250 volts.
Several pieces in stock!!
Quantity: 7 Pieces In Stock