Polished Aluminum Ceiling Light
Quantity: 12 Pieces In Stock
Free Shipping in the continental US
Click on the photo to see additional views of this nautical hanging light with brass deflector cap.
We started out with a common ceiling mounted cast brass nautical light and made it into this classy looking vintage reclaimed nautical pendant light with brass deflector cover ready to hang with 2 1/2 feet of brass chain. We added the 8 inch brass deflector cover to greatly change the look. The light measures about 13 inches long, from the tip of the handle to the bottom of the cage. It weighs about 7 pounds. Originally this light had a steel conduit pipe attached to the side to supply the electrical power. We removed the conduit and plugged the hole with a threaded brass cap.
We then added the brass handle at the top of the nautical pendant light with brass deflector cover to polish it all off. All the old wiring and bulb holder was removed and new UL-Listed parts were re-installed that are rated to work with any voltage under 250 volts. The new bulb holder takes an Edison base bulb of 50 watts or less. To access the bulb, you just spin off the brass cage and the undamaged glass globe.
This nautical hanging light with brass deflector cap will be shipped with 2 1/2 feet of chain and wire, but you will need to supply the means to attach to your ceiling.
We have five pieces like this in stock, however they are not all identical and there may be some variation between pieces.
Quantity: 1 Matched Pieces
Click on the photo to see additional views of this solid cast brass nautical ceiling light with a brass deflector cover.
This is an original cast brass nautical ceiling light with a stainless steel cage. We added the 8 inch wide brass deflector cover to this original cast brass ceiling light to dress it up a little. This cast brass nautical ceiling light will extend down from the ceiling by just about 8 inches when mounted. The base of the light has two mounting holes that are almost 4 inches on center of each other. Weighs about 7 pounds. The cage spins on and off freely and holds the undamaged glass globe in place as well as the deflector cover. Also, some of the cages may be slightly bent here and there.
The light has been re-wired with all new UL-Listed parts that are rated for any voltage under 250 volts. The bulb holder takes a normal screw in house bulb of 75 watts or less, or you can use the newer compact fluorescent bulbs or LED lights with an Edison base.
This cast brass nautical ceiling light can be used for interior or exterior lighting projects. The original conduit holes have been fitted with threaded brass plugs and a new hole has been drilled in the base to allow the wiring to exit right into the ceiling.
This is a used cast brass nautical ceiling light that was recovered during one our many different salvage operations. It will have minor surface wear from being used on a working vessel.
We have a large number of these lights in stock!!
Quantity: 75 Pieces In Stock
Click on the photo to see additional views of this nautical ceiling light with deflector cover.
We have taken an original cast brass engine room/passageway light and added the 7 inch brass deflector cover to make this very unique look. When mounted to the ceiling this light will extend down about 8 1/2 inches. The two ceiling mount holes are 5 1/4 inches on center of each other. A hole has been drilled in the base of the light for the wires to feed through.
We have re-wired this light using new UL-Listed parts rated for any voltage under 250 volts. The new bulb holder takes a normal screw in house bulb of 75 watts or less. The light weighs almost 6 1/2 pounds.
Note: The brass cage is slightly misaligned relative to the glass globe (see photos).
You will be shipped the nautical ceiling light shown in the photos.
Quantity: 1 Piece in Stock
You can see additional views of this hanging pendant light by clicking on the photo.
This vintage nautical hanging pendant light is about 17 inches tall measuring from the bottom of the cage to the top of the hanging loop. There is 4 feet of chain at the top, which can be shortened or lengthened. The brass rain cap measures 12 1/2 inches in diameter. The light weighs about 27 pounds.
These nautical lights have been totally rewired with all UL-Listed wiring and a porcelain bulb holder. They can take a normal screw in house bulb of 100 watts or less. The new wiring includes a ground wire and exits the light from the center of the light. The new wiring is rated to work with any voltage under 250 volts.
Several pieces in stock!!
Quantity: 7 Pieces In Stock